Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,In the L3/L7 ACL processing order, Does it match the 'Default permit any' rule in L3 ACL or just match the configured one?I have referred to the below document but could not see any L3 Rule which is no match but has an L7 match examples...
Hello ,How to clear stale client entries from the dashboard and how long they will stay on the dashboard, what is the timeout value for it?It creates a problem as I see duplicate IPs because the previously connected client IP address(192.168.100.50) ...
Hello Experts,On switch, I have 4 interfaces that are part of VLAN 100 and interfaces 1 and 2 have been put in Isolation but still they can reach interfaces 3 and 4.What something that's needs to be checked?-Pavan
thanks, how does it handle return traffic, does it follow the same pattern as mentioned in the document if so then for return traffic we need to create L3,L7 ACL ?
what if there is no match in L3 ACL , if traffic with port 513 and there is no matching L3 ACL rule so will it match the Default permit L3 rule and bypass L7 or it will go to L7 as no match in L3Layer 3 RulesNo matchNo matchNo matchDoes Default permi...
i have gone through the document,what if there is no match in L3 ACL , if traffic with port 513 and there is no matching L3 ACL rule so will it match the Default permit L3 rule and bypass L7 or it will go to L7 as no match in L3and what about reverse...
