hi all i have a pix 506 connected on ppoe(adsl)everything was ok I turned if of for a week while i wasn't in office when i powered it back i had this. the interface "int e1 is up protocol down" "dhcp command failed Nat 0.0.0.0 will be-non ...
hi all just got a pix 506 with ios 5.2.xx want to reset it tofactory default there's a password how do I set it up to factory default? or change the password ? how do i run pix device manager for gui configuration I am new to thisthanks
hi all just got a pix 506 with ios 5.2.xx want to reset it tofactory defaultthere's a password how do I set it up to factory default?or change the password ? how do i run pix device manager for gui configuration
thanks i go it back and running since it uses the ppoe and a loging to isp did changed i had to modified the loging and the internal interface had a cross cable attached to the switch(initial config with the 501) i had to plug a straigh...
