Re: dhcp fails to load on pix 506/int e1 inside is up line proto

johnnym33 · ‎12-18-2003

hi all i have a pix 506 connected on ppoe(adsl)

everything was ok I turned if of for a week while i wasn't in office when i powered it back i had this. the interface "int e1 is up protocol down"

"dhcp command failed Nat 0.0.0.0 will

be-non translated!"

I can't connect trought pix device manager anymore

can any body give me some advice ?

******************************* Warning *******************************

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

....................

DHCP command failed

nat 0 0.0.0.0 will be non-translated

Cryptochecksum(unchanged): xxxxxxx

Type help or '?' for a list of available commands.

pix506>

Hardware is i82559 ethernet, address is 0004.2746.2746

MTU 1500 bytes, BW 10000 Kbit half duplex

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

9 packets output, 5310 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collisions, 0 deferred

9 lost carrier, 0 no carrier

input queue (curr/max blocks): hardware (128/128) software (0/0)

output queue (curr/max blocks): hardware (0/1) software (0/1)

interface ethernet1 "inside" is up, line protocol is down

Hardware is i82559 ethernet, address is 0004.2746.2747

IP address 192.168.1.1, subnet mask 255.255.255.0

MTU 1500 bytes, BW 10000 Kbit half duplex

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

1 packets output, 60 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collisions, 0 deferred

1 lost carrier, 0 no carrier

input queue (curr/max blocks): hardware (128/128) software (0/0)

output queue (curr/max blocks): hardware (0/1) software (0/1)

pix506(config)#

jmia · ‎12-19-2003

Hi,

If your interface is showing up/down, then I would suggest that you check the telco/ISP side.

Hope this helps and let me know how you get on.

Jay.

johnnym33 · ‎12-21-2003

thanks i go it back and running since it uses the ppoe and a loging to isp did changed i had to modified the loging

and the internal interface had a cross cable attached to the switch(initial config with the 501) i had to plug a straight cable instead and it worked

no pbmes

dhcp fails to load on pix 506/int e1 inside is up line protocol is down !