Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is the result of the command show crypto pki certificates: AP32>show crypto pki certificatesCA CertificateStatus: AvailableCertificate Serial Number (hex): 01Certificate Usage: SignatureIssuer:cn=Cisco Root CA M2o=CiscoSubject:cn=Cisco Root CA M...
And a few minutes later:Not in Bound state.*Sep 11 09:33:52.503: %CAPWAP-3-DHCP_RENEW: Could not discover WLC. Either IP address is not assigned or assigned IP is wrong. Renewing DHCP IP.*Sep 11 09:33:55.575: %DHCP-6-ADDRESS_ASSIGN: Interface BVI1 as...
Indeed with a third cable worked. Bad luck.So here are the logs:*Jun 26 22:26:57.555: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed state to up*Jun 26 22:26:59.775: %DHCP-6-ADDRESS_ASSIGN: Interface BVI1 assigned DHCP addr...
Also tried with no Flow Control and I'm using the console port:tested on other pc and I'm sure about the COM port used but the connection does not go trough on putty.And also tried with other AP so I suppose I'm doing something wrong.I think I need ...
Thanks for your reply. Any official instruction I can take a look to see how to connect to console on AP?I'm using the same cable I use on switchs that usually works fine and struggling to be able to connect on AP.COM port on PC works fine and bellow...
