Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a Cisco 1242 ag, but I can not configure it I try to press mode on start but nothing makes the status LED blinks green, red, orange radio red or orange et ethernet in Green, when i try to connect with such net it tells me Password requi...
Hello, when it presses on the console it happens this status blue radio blinks green, status yellow ethenet red for about 40 sec then status ethenet green all three, status white, status green radio flashes red, staus flashe...
I tried the LED status turns yellow and the orange Ethernet LED, and after it restarts 3 green LED then red green green status and green Ethernet but still unable to connect thank you
I use Putty for the break command you have to do a right cli and select special command and then break, no I have not found the program to install thanks to you.
