About julomban1

julomban1 · 08-18-2021

Hello All, I have a 2100 appliance running ASA image on it, I was able to point the ASA module to TACACS server for authentication however when I try the 2100 chassis itself, the AAA option is not available under platform settings (GUI). I have anot...

julomban1 · 05-23-2017

Hello Everyone, Between the 3850 and ASR we have some vlans configured, all with OSPF enabled. There is a main/prefer vlan that goes through another set of routers, one of those routers went down and OSPF also went down. This affected OSPF between ...

julomban1 · 08-18-2021

Thanks, Rob, Do u know if there is an enhancement request to allow this in the future?

julomban1 · 08-18-2021

Thanks Rob, so I can only use local authentication for the chassis?

julomban1 · 09-18-2018

Everything inbound doesn't seem to be working... We can see on the router's routing table the route been learned via the firewall so we know bgp is advertising the route correctly, however, we can't pass traffic. Unfortunately, our MX window was o...

julomban1 · 05-23-2017

Hi Julio, Not really but now that you mentioned it could be a solution, using the loopbacks.

Member Since	‎05-23-2017 03:21 PM
Date Last Visited	‎08-25-2021 12:34 AM
Posts	6

User Statistics

User Activity

Cisco Firepower 2100 - Unable to configure TACACS on chassis

OSPF between WS-C3850 and ASR1001-X

Re: Cisco Firepower 2100 - Unable to configure TACACS on chassis

Re: Cisco Firepower 2100 - Unable to configure TACACS on chassis

Re: juniper netscreen with loopback interface to Cisco ASA

Hi Julio,