Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone tell me how they may have done this without any fancy tools? Can you schedule something within the IOS to automatically send the config say every week? Or have you used a particular TFTP server that would execute a script to automaticall...
I have been using the bandwidth command, but it appears ineffective. File transfer speeds are consistently about 50kbps regardless of the speed I set using the bandwidth command.thanks,
Can anyone explain the correlation between response time and circuit utilization? We have put a 20% load on a test network and see response times climb from 18ms to around 190ms. Is this normal? If not, what should it be? Is there a formula of so...
I had the same problem with some 1231 APs with a 4402 controller. If you watch the APs console while it is rebooting, you'll notice that it can't get a certificate. I finally figured out that the time was different (wrong time zone) wrong on the co...
Yes, I am connecting the two with CAB-V35MT (DTE) and CAB-V35FC (DCE) cables. You are right about the speed, I was just spewing that as an example. Up to 1.5mb is fine, if I could get it to work.
Good point, I should clarify more. I have setup a test WAN network in my office with two routers (a spare 2621 and 1721) each with a WIC-1T card installed. Connected with the appropriate V35 cables. I expected to be able to modify the speed of the co...
Good point, I should clarify more. I have setup a test WAN network in my office with two routers (a spare 2621 and 1721) each with a WIC-1T card installed. Connected with the appropriate V35 cables. I expected to be able to modify the speed of the...
