Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Yes its ok coz in ospf Ethernet 1 router be a DR(highest router ID or highest ip address on loopback if not then on interface or ethernet) and 2nd BDR(2nd highest router ID or highest ip address on loopback if not then on interface or ethernet) and o...
hello you can do that with static route ip route 0.0.0.0 0.0.0.0 serial 0 192.168.0.1ip route 0.0.0.0 0.0.0.0 ethernet 0 168.16.0.1if your both links are up so then you can use simultaneously both links and if one links gose down your all trafic go f...
Hello if you ping the server from outside thats mine its wroking fine so just ACTIVE in your server telnet service then you can telnet your server.so check i think its work ..........
hi For IS-IS first uprade your Router IOS to new ver and after first on config mode R1(config)#clns routingR1(config)#router isisR1(conft)#net xx.xxx.xxx.xxx.xxx.xxR1(conft-int)#ip router isisRegards,Mehmood Sajid
