Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm stuck with this scenario, I have read a lot of information on Internet but it doesn't work:
I need to configure a second SSID only for guest access, isolated from LAN data:
2x Access Point Linksys LAPAC1750PRO
Switch Cisco SG200-50p
Route...
Wow! I have just realized that I only set VLAN ID=10 for guest wifi on the 2,4 GHz radio!!!
The 5 GHz radio wifi was still with VLAN ID=1, and all my tests are with a Macbook, then is impossible to connect to VLAN10!!
The next time I will go to thi...
The only problem is when the PC on VLAN10 gets IP, I only can ping to devices on this LAN segment, not to the VLAN1 devices LAN segment.
What I have to change on the switch setup?
I have some news.
If I add port 10 on VLAN10 type ACCESS, not trunk, and plug a PC on this port, the PC receive IP address from the range of VLAN10. This is perfect!
But then, on VLAN1, this pots sets automattically as Excluded and I can't set it as...
