About cbuster35

cbuster35 · 07-22-2012

Need some help with STP, I have not run across this issue before and have set several of these IE3000 switches up in my own environment with no issues. This gear is at a remote site that I am trying to help out.VLAN 100 is for management, VLAN 125 is...

cbuster35 · 05-19-2012

Using a 3750V2 switch leaving the port set to the default ‘auto’ most (70%-80%) connected nodes negotiate at 100 / Half or 10 / Half. Only a few negotiate to Full duplex.What would cause this type of behavior? The nodes range from Dell, HP, computers...

cbuster35 · 05-15-2012

I have a question around a configuration that I wanted to throw out there and get some feedback on what I should do to satisfy this requirement.The requirement is to securely isolate traffic between our traditional office network and our R&D network....

cbuster35 · 07-23-2012

Thanks Peter, I realized after posting I misstated blocking. I have never seen a port in BKN mode before. I did discover that the IE3000 defaults to spanning tree mode mst when using their express setup. Not familiar with mst configurations, but that...

cbuster35 · 05-19-2012

I found this to be true. The last network person was setting the client devices to 100MB full duplex. Was a nortel environment. Even hard coding to 100 full would let it go to half duplex? I will change some back to auto/auto on Monday when I get bac...

Member Since	‎05-15-2012 03:32 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Spanning Tree Issue Root in BKN* State

Auto Negotiation Issue

Logically Isolate Networks on the Same Physical Hardware

Re:Spanning Tree Issue Root in BKN* State

Re:Auto Negotiation Issue