Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am looking for some advice or indication if this can be done or not. A client with a critical industrial control system has 4 /30 subnets at 4 sites connected via BDSL routers to a carrier. The BDSL routers occupy 1 IP address on the LAN s...
Hi All,I am looking at emulating a system similar to the following using VRF-lite on a 3750. Please see the attached diagram.To expain:1) The hosts share "Virtual IP addresses" and announce which ones they have to the upstream routers, then on up to...
Hi All,We have a Site to Site VPN set up with a customer's network and all works well from our Workgroup LAN on the inside interface of an ASA (8.0(4). The tunnel is created and traffic passes over it fine. We also need remote users using the Anyco...
Hi All,I am trying to configure separate WebVPN connection profiles to give different portal bookmark contents to users based on their AD group membership. This has been very difficult, even though I beleive it should be easy.The login page of teh A...
Thanks Richard,I will review the article and make a decision about it. I would only be using static routes in this scenario, as it is simply using the carrier based VRF for point-to-mulit-point comms. ie, each site's /30 subnet can see each other s...
Thanks Giuseppe,I guess what I wasn't clear on is our Production Network supports hosts and systems that are mostly used for testing and development. We (I) created an emulation of the required structure using a Linux host, but during load testing t...
Hi James,Thanks for the thoughts, but the logs do not show which ACL is being hit.If the packet-trace output is to be belived, the ACL id is 0xcccdc4a0, which does not appear in a sh access-list output. This would indicate that it is an implicit rul...
