Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
As per Leo Laohoo 's recommendation - starting a new thread instead of adding to 'https://supportforums.cisco.com/discussion/10877506/ap-fails-join-controller'. The temptation to interject into that thread was too much - seeing that manjil.bhetw...
Hi,We are configuring our MDS switches for new storage and there are a couple of options. I am not sure which is the best way to go.We have 6 x 9124's. Our new storage has plenty of ports. Each of the 6 x 9124's will be connected to 2 ports on the...
Hi,The latest SAN-OS is 3.2(1), and a new "feature" in this release is that Fabric Manager no longer lives in the switches (you can't install it from the switch web interface anymore, only Device Manager is there). Instead you get a page telling you...
Mario - if there is a final answer to this, then I never found it. My fleet of 1532s is much smaller than yours; so is manageable even with this quirk. I imagine if you were ordering 80 units, there would be a distinct possibility of consecutive MAC ...
Hi Leo,
This was the answer we were looking for. Unfortunately I had already found it at: "http://www.networkoc.net/cap1532i-does-not-join-the-wlc/" - but the WLC reported an entirely different MAC address from the AP. I.e. *Definitely* use the MAC a...
