Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I go into WCS it shows me a chart oh how many people have connected on certain dates.One bar on the graph is blue which means assoicated clients. It tells me I have 40.The other bar is gold or yellow. It tells me I have 38.We might have 2 people...
I reset the ap and it didnt change anything. When I go into wcs under configure/access points it tells me my ap is down. The controller tells me its up and it looks good. In wcs it even lets me click on the so called down 1131 ap and make changes to ...
What does it mean when your 1131 access points are flashing orange or amber.Its not showing up on my 4404 controllers. I think its a bad run from the wireing closet to the ap.
What if you wanted to add an AP outside in a garden area. How do people usally go about that. You would have to mount it to a tree or post of some kind. Digging a cable underground sounds expensive.
I managed to get the controller back on the WCS. How do I clear the database like you said? Is it done on the WCS or the controller?removing and readding the first controller that the AP in question was on didnt fix the issue of WCS telling me the AP...
Where do I go to clear the database conflicts ?I just removed our first controller. from WCS. The aps seem to be running fine still. I can't get the controller back on. When I enter in the same information I recorded from when the controller was adde...
whats involved with removing the adding the controller? Would you be able to point me at some documentation?Also, I have 2 controllers. The first is used for all the aps, the 2nd is used for fail over. I would only need to remove the 1st controller r...
