Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we have a bgp peering session with our isp on ipv4 and are learning our default gateway through it. In parallel we have also an ipv6 peering session with the same ISP which allows us to learn the ipv6 default gateway. But through this second bgp s...
Hi,I'm a bit puzzled by the documentation for the WLC concerning the service-port interface.In the "WLC and LAP basic configuration example" documentation it is said: "If you do not want to use the service port, enter 0.0.0.0 for the IP address and n...
Hello,not sure wether this is a bug or not but when running 'show dhcp leases' on a WLC4402 (running 5.2.157.0) I get something like this back:(Cisco Controller) >show dhcp leases MAC IP Lease Time Remaining00:21:6b:c2:f...
Hello,I would like some clarification on the Mobility groups behaviors. We have 2 WLC 4402 (wlc-a and wlc-b) setup on the same DMZ and 30 AP connecting to the first one (wlc-a). We have setup the same mobility groups on both WLC. AP failover betwen t...
Of course!!!!You are completely right this immediatly solves the problem. I was so focused on the IPv6 section that I completely overlooked that line.Thanks a lot,Seb
Hi,thanks both for the answers.We are using the console port of the wlc for remote OOBM. In our case i don't see the point in putting up anything on the service port in terms of configuration. I merely wondering if we still have to configure it or no...