Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In SD-Access solution. In case of ISE totally down is it possible to create multiple critical vlans for each VN for example one critical vlan for users, another one for IOT devices and third one for voice.or it must be single critical data vlan for t...
I have an existing WLC contain Four branches only one of them will use SD-access. the other three branches will remain as a legacy all the AP using flex connect.for head office users in order to get the same IP for wire and wireless the WLC should be...
In my design I have legacy wlc will not join the sda fabric. Connected to legacy core switch
I want to use INFRA VN for the access point ip pool but I’m confused how to add option 43 to connect the fabric AP to the legacy WLC
normally in traditional ...
Thank you so much for your clarifiaction for the ISE, it is not possible to use two ISE admin nodes in DNAc so I will migrate all the polices from legacy ISE to the new one which is integrated with the DNAC.I will use virtual WLC to be provisioned wi...
Thank you for your guidance.
I noticed two limitations in DNAC:
One network profile per site
Since each site can be associated with only a single network profile, my workaround is to create two building-level sites under Global for HO: HO_Legacy ...
I agree that in a greenfield deployment, SSIDs are created in DNA Center, network profiles are assigned for fabric and non-fabric branches, and then the configuration is pushed to an empty WLC.
However, in my case, the SSIDs are already created and w...
I will connect the WLC to the legacy core switch then to fusion Firewall then to the border node.so, BN will get reachability to the WLC this is not the issue. The challenge is how to use the same SSID for legacy and fabric at the same time As part o...
