Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am testing CW9166I-ROW Cisco APs running IOS‑XE 17.15.04d on a C9800CL-vWLC. When the country code is set to 'IN'(India), the 6 GHz radio remains down. If I change the country code to AR (Argentina), the 6 GHz radio comes 'UP', but the 6 GHz SSI...
HiWe are using a CW9166 Access Point managed by a C9800-CL Wireless LAN Controller (vWLC) running image C9800-CL-universalk9.17.15.*Through the vWLC GUI, underConfiguration > Radio Configuration > High Throughput,we reduced the number of spatial stre...
Hi,We have connected a C9800-CL Wireless LAN Controller to a CW9166 Access Point using the image C9800-CL-universalk9.17.15.01.iso.What is the command to check the power or current consumption of the CW9166 Access Point via the C9800-CL WLC CLI or GU...
Hi,Regarding the setup of Cisco Spaces Connect for IoT Services with our C9800CL Wireless Controller, we are experiencing an issue with the Data Receiver Application. After re-registering the Data Receiver Application and subscribing to the appropria...
Hi,We are using the Cisco Catalyst C9800-CL Wireless Controller with IOSXE-17.14 and plan to upgrade to IOSXE-17.15 for BLE support, so we would like to know the expected release date for IOSXE-17.15.
Can you please confirm whether the IOS‑XE image 17.15.4 and 17.18.2 version released in December last year includes support for 6 GHz operation in the India (IN) regulatory domain? and alsoIs there any upcoming IOS‑XE image planned that will add 6 GH...
Hi @Saikat Nandy The commands shown display the maximum supported spatial streams for the client .However, this does not explicitly showing the currently active or negotiated spatial streams in use.Is their any Access Point CLI command to read the nu...
Hi @Mark Elsen We have configured the vWLC controller as shown in Figure 39, as you referenced.Is there a CLI command available on the CW9166 AP itself that can be used to verify the following:The currently supported or active spatial streams per rad...
Hi @JPavonM @Rich R 1. I’m currently observing multiple rogue AP entries under the Monitor > Rogues section in the C9800-CL GUI (running IOS-XE 17.15.1), many of which are marked as “Unclassified”.-> Could you please clarify the operational significa...
