Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
I got two routers on different location connected through p2p link. There are two ISP providing P2P connectivity. I am running EIGRP both side over p2p line.
Problem- When an ISP goes down I need manually shut that ISP port to switch comp...
I can ping an IP address but not traceroute. When I am trying to traceroute getting below response. Could anyone assist me to resolve it.
1 * * * 2 * * * 3 * * * 4 * * * 5 * * * 6 * * * 7 * * * 8 * * * 9 * * * 10 ...
Is there a way by which we can block all the connections from a country on Cisco ASA, without we manually defining a ACL.
Hardware- Cisco ASA5510-
Version - 9.0
Is there a way by which we can block all the connections from a country on Cisco ASA, without we manually defining a ACL.
Hardware- Cisco ASA5510-
Version - 9.0
Mark,
We use rout-map in IP SLA when we need to got to internet. Its not an internet line. Its a p2p connection for internal traffic only.
Thanks,
Nilesh
Hi Mark,
Its an old setup and loopback is not defined so I can not use that. I can try physical interface address. Router is not accepting the default timers. Even its not accepting 2000 time/250 tres/ freq 3. Its only accepting above than 6000 time....
Please find the IP SLA config. Tunnel interface status is down but IP SLA statis is ok and traffic is not moving on other link.
# IP sla 1 # icmp-echo 172.17.1.2 source-interface tunnel 1# time out 2000# treshhold 250 # frequency 3 # ip sla schedule...
I have configured IP SLA on router but it seems not working properly. ROuter interface is down but IP SLA does not track and switch traffic on other link.
I do not know if Cisco 1941 support IP SLA tracking feature not as there was no option to conf...
