I already have the router set up running the Internet through it just fine. I want to connect my 2950 Switch to the FA1/1 port of the WIC4-ESW card. I assumed it would have to be trunking or other vlans would not be allowed. I currently have ...
I am trying to connect my Cisco 1760 router inline so I can use it and practice my ACL's. I want it to go in this sequence: linksys BEFSX41 firewall router switchport >>>>> Built in FA0/0 port on my 1760 router >>>>>> out the FA1/1 port on the WI...
I finally got it working. It is currently: NIC>>>>1760 Router>>>>>Linksys BEFSX41 Firewall Router>>>>>>>DSL modem>>>>Phone Line
And it is carrying the Internet in both directions.
Thanks for the help
I attached a file that shows pics of all t...
This Show Run post is the one I said I would post that is is reference to the post right after this one. It did not put this post after my last post, that is why it is showing up before the post it is in reference to, so you will need to read the n...
So I assume that since the FA1/1 on the WIX4ESW card is going to be connected to my PC, I will need to change the PC's NIC to the 10 network?
Then the routers routed port will still be the 192.168.1.53, and I will have to adjust the BEFSX41 so that ...
Yeah, I do have some VLANS in there. I could take them out. The reason I had the 192.168.1.53 is because it is the same network as the linksys. It may complicate things if I try to keep the 10 network. Can you describe to me how to do this witho...