Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have tried any config guide and the problem persits, i think that it may be related to the dialer that need to be bridge to cellular or some configuration to the gateway because the system seems like it doesnt work alone with cell by itself and i c...
hello i am trying to configure my cisco 829 with this simple code snipped but the device refuse to ping 8.8.8.8 or 0.0.0.0 etc and the cellular 0/0 or 1/0 refuse to get ip address, i use a generic sim card and i dont know if the problem is related t...
hello i am trying to configure my cisco 829 with this simple code snipped but the device refuse to ping 8.8.8.8 or 0.0.0.0 etc and the cellular 0/0 or 1/0 refuse to get ip address, i use a generic sim card and i dont know if the problem is related t...
as the title said, i am trying to get the cisco IOs IR800 to boots in rommon2 with SCP , FTP but with no success, so if someone can send me the IOS i would be happy.
i have checked already and it did not work, this is my sh running-config and the model of the device is IR 829 2LTEEA 8K9, i am using a IOT sim card from Eliotclub Current configuration : 3777 bytes!! Last configuration change at 19:32:26 UTC Tue Ap...
and this is my sh cellular 0/0 profile To:YouTue 30/04/2024 16:15R800#sh cellular 0/0 profile Profile 1 = INACTIVE--------PDP Type = IPv4Access Point Name (APN) = noneAuthentication = None Profile 3 = INACTIVE* **--------PDP Type = IPv4Access Po...
