I have been told that the new CSPM software could performing shunning without the Director software. The version i and f provide that shunning feature I was told. Can anyone confirm or deny this for release 2.3?
If you will notice the frame relay subinterface does not allow you to put the link status command on the actual subinterface. The command will work on the gloabl interface but it will not trigger the trap on a link status change. I am still looking ...
I would be interested in knowing how syslog will provide you this functionality since it is operating by default on 514 and trap receiver is on 162. I am working on getting this exact same information from a 7206 at this time and I have found that t...
We to are running Unicenter 3.0 from CA. I have not yet tried to make this happen yet in our implmentation, but i would not hesitate in saying I think it should be a TCC question more so than a TAC question. I would be very interested in speaking mor...
I to am having the same problem. I have a tac case open and we are about to start working with prod development to get a work around. I will keep you posted.
In my opinion you have to be good at CLI. It is a lot like high school when you could not use a calulator until you understood how to do it on paper. The tools are good adn do provide a good interface. It never replaces a good engineer who can get ...
