Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A recently deployed ASA 5516 with basic configuration is logging a ton of %ASA-7-725011 syslog messages .
Here is the specifics to the device:
--------
Cisco Adaptive Security Appliance Software Version 9.6(2)13 Device Manager Version 7.6(1)
Hardware...
Hi All,To fix SSLv3 and Poodle vulnerability on ASA 5520 running code 8.2(2), will the command "ssl server-version tlsv1" do the trick or do I have to upgrade the software version? If I can fix this without a software upgrade, it would b great. Whil...
Hello all,I have always done my port monitoring (SPAN) on Cisco layer 3 switches with no issues. This time I am trying to do this on a Cisco 2901 router:Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.1(4)M2, RELEASE SOFTWARE (fc...
I am sure sombody else has encountered this before:I have stack of 5 x 3750 switches configured with several VLANs, no issues. (VTP is set to Server on this stack)I also have an older 3550 which has a trunk interface conneciting to the 3750 stack. (V...
Hello,I apologize in advance for the lengthy description, but I wanted to give an accurate picture of this scenario.OK, here we go?In order to address company?s need for faster and better connections we are upgrading our WAN infrastructure with some ...
Yes - I think that is the case - How is it possible that a brand new ASA has customized logging buffered setting (?) - Here is the output you requested. Thank you
#show run logging
logging enablelogging timestamplogging buffer-size 52428800logging as...
Thanks but..... Here is my logging config - Doesn't seem like ASDM debuging is enabled - In fact the output of command "sh logging asdm" does not include the 725011, so it seems to me the source of these logs is something else.
Syslog logging: enable...
Thank you! I believe the "New NAT" was introduced in version 8.3, so upgrading from 8.2.2 to 8.2.5.55 should be straight forward.With that said, according to the page below, I also have to upgrade Any-Connect clients to version 4.x and higher. At thi...
