Hi all, I have configured my 1841 to pickup ntp service as below: scheduler allocate 20000 1000 ntp clock-period 17178609 ntp update-calendar ntp server 130.88.200.4 and my switch to set the time locally from the above router on its Fa0/0 port as below: ntp clock-period 17179885 ntp server 192.168.2.1 end All the above is working as should be... But i cant get my windows 2008R2 server to pickup the time from the GW Router (above) on the 192.168.2.1 IP, is there anthing that i need to do on the router to enable this? i have tried setting ntp broadcast on the fa0/0 port on the router but again the sever couldnt pick any time details up. Im not sure if this is possible, as i haven't seen this setup in any production enviroments! Thanks in advance, Paul ... View more

Anyone have any idear what could be cuasing the issue is it a Telco issue? E1 0/0/0 is down. Applique type is Channelized E1 - balance Description: BT ISDN-30 IMBT Pilot Transmitter is sending remote alarm. Receiver is getting AIS. alarm-trigger is not set   Version info Firmware: 20060711, FPGA: 13, spm_count = 0 Framing is CRC4, Line Code is HDB3, Clock Source is Line. CRC Threshold is 320. Reported from firmware  is 320. Total Data (last 24 hours) 0 Line Code Violations, 0 Path Code Violations, 0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins, 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs also on log: Nov  7 06:43:39.654: %LINK-3-UPDOWN: Interface Serial0/0/0:15, changed state to down Nov  7 17:09:43.596: %MARS_NETCLK-3-HOLDOVER: Entering Holdover for Controller E1 0/0/0 Nov  7 17:09:53.844: %MARS_NETCLK-3-HOLDOVER_TRANS: Holdover timer exceeded for Controller E1 0/0/0 Nov  7 17:09:53.844: %MARS_NETCLK-3-CLK_TRANS: Network clock source transitioned from priority 1 to priority ... View more