Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on C9120AXI in a lab at school, so this will not be used in production but for education purposes. I followed this link https://www.cisco.com/c/en/us/support/docs/wireless/embedded-wireless-controller-on-catalyst-access-points/215303-emb...
Thank you for confirming my configurations. All I needed was to do a factory reset as suggested and it worked! Without the factory reset it wasn't doing the auto install after booting so that's why I'm guessing my configurations didn't work. But now ...
I'm using Cisco IOS XE Software, Version 17.09.04. I have tried to adjust my configurations as requested. Still doesn't work. Thank you for the suggestions, I have gone through a lot of topics in the Cisco community on WLC. Unfortunately, I can't see...
Here are the requested configurations. I have tried Trunk as well as Access on the switchport connected to the WLC, right now I left it as access but neither worked.
