Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a single bluecoat proxy that is exposed to internet , which we need to add another one and load balance traffic to both of them . The problem is that this traffic cannot be routed to proxy explicitly ( i.e not like the Ineternet Explorer ) s...
Dears ,I have upgraded my WLC from version 5.1.151 to version 6.0.202 and then to 7.0.116 .Since when , I see that all clients are disconnected every around 20 minutes and re-connected again .Does anyone has any clues ?WLC is 4402AP are AIR-LAP1231G-...
Are you having Quad-SUP set-up or what ?As far as I know , "redundancy force-switchover" can help from an active SUP to a standby one on the same Chassis , but not from a chassis to another .
Hello Abhisar , I believe what you are aiming is a typical scenario of a Quad-SUP design , where you have to install 2 SUP's per chasse , and this is where a soft fail-over can be performed without box reload .BR,A K
Can you print out arp results at both servers at the problem time and at the normal operation time ? Also can you you print our arp for the 3 IP's ( 2 physica and 1 VIP ) at the problem time and at normal operation ?I know this is somehow out of cont...
Hello ncowger ,I am planning to have similar change recently on our DC Nexus switches (7K as well ) , my plan was to use the command ip route 0.0.0.0 0.0.0.0 172.28.0.5 vrf SecureServerso it's like message for me not to use it what IOS are using ? a...
