Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2x stack of Cisco 9200's in a production environment. While i was setting them up and installing them, I used a hardcoded username with privilege 15 and a secret to SSH into the switch and go directly into config mode. However, I must have...
So i tried this idea first as it was the most straightforward, and It did not work.There is no service-type = Shell-User on my radius server. The choices I have are:AdministrativeAuthorize OnlyCallback AdministrativeCallback FramedCallback NAS Promp...
I couldn't get this to work no matter if the host pc's on each switch were in the same subnet or not. Switchport mode access between the two switches seems to prevent any vlan hopping
