I'm in process of updating from ESXi 6.5 to 6.7 Update 1. I have 6248 Interconnects, B200 M3s 2600 series processors, with the 1240 VIC installed on them. I went on Cisco's HCL page to see what drivers I should use withe 3.2(3) firmware. I see it...
We would like to begin planning our upgrade to ESXi 6.7 and continue to use our existing investment in our B200M3 series. I go on Cisco's HCL list page https://ucshcltool.cloudapps.cisco.com/public/
put in B Series, B200 M3s, Intel Xeon E5 2600 Seri...
I'm in process in upgrading in upgrading to UCS 3.1 code. I have older Chassis 5108, PID N20-C6508. I have older 2104XP , PID N20-I6584 I know they don't work in 3.1 code. I have Power Supplies PID N20-PAC5-2500W, I don't if they will work or not...
We are seeing fcpio_data_cnt_mismatch in our vmkernel.log on one of our 10 esxi hosts running esxi 6.0 update 2. We are using fnic_drive 1.6.0.28. We started out with firmware 3.1(1k) and have upgrade firmware to 3.1(2e). It seems to be very simi...
We have recently purchased a VMAX 450F(All Flash Array) and would like to be directly connected to 9248 Interconnect Switches so we won't need our MDS 9148 switches anymore. All of the servers that we will have on the SAN will UCS managed servers. ...
samtech,
We used to run our Fibre channel tape library connected to our mds switch with UCS blades. We did it under redhat and we did get it talk as a vm as well but we never did that in production. It's been a few years ago. We had an IBM TS33...
1) My meaning of support is similar to your statement, with the expectation of continue to support newer OS except in the last year. I wouldn't expect Cisco to add a new OS on the last year a product will be supported.
2) If there are plans to t...
Balram,
On question 3, if you mean HA cluster like VMWare cluster HA? Then you should be able to do EVC mode but it must be set at oldest chipset model.