1. Yes. Make sure that all the faults clear out on the UCSM side and the vEth paths re-pin before proceeding to the primary side after re-acking subordinate to maintain redundancy.   2. Yes. In older firmware versions an entire chassis re-ack was required. In later firmware releases, we give you the option to re-ack the IOMs only. ... View more

Can you confirm what RAID you are using? 0, 1, 5, 10 ?   If the replacement drive is stuck at unconfigured good, depending on your RAID configuration, you can select to "add as global hot spare" for the Virtual Drive in question and it should start rebuilding after replacement.   If you still have questions, the more details and screen caps you can provide the better. ... View more

For VNIC 14 lifid 3 you are not getting a nameserver query response, meaning that you are not zoned correctly on that path to storage. You need to check N5K and make sure 21:00:00:1b:32:04:37:dc is in the correct zone.   For VNIC 16 lifid 5 you are zoned correctly as the WWPN does show correctly in nameserver query response. However, it looks like you are not being assigned an FCID from the N5K, hence you are not getting any Report LUN Query Responses. Check the FCNS database and 'show zoneset active' to ensure the WWPN are showing with a "*" for initiator and target. ... View more

The best way to troubleshoot this is conduct the following:   1. Boot the server and press F6 to select a boot option. Leave the server at the selection screen.   2. SSH to primary FI and run the following commands:   UCS#connect adapter 1/3/1 #connect #attach-fls #lunlist   These outputs will let you know where the problem exist. Can you post the outputs? ... View more