Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have one more issue that I would be extremely grateful for help with. When I check the AP join statistics I see the following:Reason For Last Unsuccessful Attempt RADIUS authorization is pending for the API don't run a radius server and don't...
I have more information that might be helpful:I have a 4402 controller. I have further seen that the 1142 is somehow in mesh(bridge mode) and as such wont attach to the controller be cause the controller wants its mac address for authentication again...
I have the following routersRouter 1Interface IP-Address OK? Method Status ProtocolFastEthernet0/0 192.168.192.20 YES NVRAM up up FastEthernet0/1 63.232.181.14 YES...
I have the following routersRouter 1Interface IP-Address OK? Method Status ProtocolFastEthernet0/0 192.168.192.20 YES NVRAM up up FastEthernet0/1 63.232.181.14 YES...
I have the following routersRouter 1Interface IP-Address OK? Method Status ProtocolFastEthernet0/0 192.168.192.20 YES NVRAM up up FastEthernet0/1 63.232.181.14 YES...
These posts are very old and the link that you offered is no longer any good. I needed some help with L2TPv3 and was hoping that someone was still monitoring this forum. I have two routers and wanted to run L2tpv3 so that I could extend by VLANS. Can...
