Richardsma
Level 1
Level 1
Member since ‎02-18-2009
‎08-18-2017

User Statistics

  • 22 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received

User Activity

Hi,I'm seeing the following error on a 4500 running 12.2(46)SGC4K_IOSMODPORTMAN-4-INLINEPOWEROVERWARNING: Module 5 inline power exceeds threshold: status changed to 'Pwr Over'All the ports on module 5 have "power inline never" applied, in fact the wh...
Hi,I have a 1500 device install of LMS 3.0.1 but didn't install the 30 day evaluation version of HUM. Can I install it retrospectively or do I have to start again?I'm looking to upgrade to version 3.1 in the very near future but wanted to try out HUM...
Apologies if this is a stupid question but where do RME Reports get the "Device Name" from? I'm asking because on a few reports I've tried to run, Inventory or Software Versions, I sometimes see either the IP address or the device name. I've even had...
I have a pair of 6513's each connected to the same ISP via POS. Occasionally I see the attached messages in the logs and not being very comfortable with BGP I'm not too sure about who's not speaking to who!Is the ISP dropping connection or are the tw...
Hi,I'm trying to create a custom report template so that I can capture asset details for the installed hardware. So far I can get the details for the chassis, linecards, and Sup card but I can't seem to find the variables which will report the detail...
Community Statistics
Member Since ‎02-18-2009 02:28 AM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 22