Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to replace an older switch with a new switch but whoever configured the old switch configured the interfaces with this:interface FastEthernet0/12 description Center Lab switchport access vlan 214 switchport trunk encapsulation dot1q switc...
I have a new 5520 ASA that I am putting on to the network tonight. I set up the management port with the address of our management subnet and have it plugged into our core switch but for some reason I can't reach it via SSH, telnet or the ASDM. I hav...
I currently have an ASA providing VPN access into our network. We want to enable client to client communication that looks like it will require that we set up hairpinning via the "same-security-traffic permit intra-interface" command. My boss would l...
Hello,I am trying to set up a router that has a pretty simple setup. It has a private inside network that NATs out to the external internet. I just need to know if I have to enter a particular command to allow VPNs to pass through the router. I thoug...
I have 2 2801 routers that need to run BGP. Unfortunately my boss bought them with the advanced security version of IOS on them and not the advanced IP services I need to be able to run BGP. I was able to download the advances IP services version of ...
I'm not sure if this is workable in your situation but if your IT department works on a particular subnet that's smaller than the 10.128.100.0/24 subnet you could put that in to exit the management interface. We had a similar problem with setting up ...
Point noted and laughed over! I, on the other hand, am nothing near dignified. I'm laughing at these messages like someone slipped me some laughing gas and my co-workers are wondering what I'm up to over here. I'm from Seattle and we're just laid ba...
ROTHLMAO! You both are hilareous and have given me quite a laugh (in addition to helping me with my question). So a big thanks to you both!In all fairness to you Jon, you did say that you thought the interfaces would be using VLAN 214 and not 112 so ...
Sorry Jon...I just couldn't resist. I know I'm too softhearted but what r u gunna do? It's just the way I am. Besides I don't know Victor like you do. I'll try to resist better next time.
LOL! Well I'll give you 5 too since you led me to putting in the command I should have in the first place. Now you have 10 points..hope your day is looking up!
