Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On the CML sandbox, the gateway of 10.10.20.254 for the management network is not reachable. This should be accessible via connectivity to the external connector on network 10.10.20.0/24.Since the gateway seems to be inop, I am also unable to intera...
Hello,On the Cisco Crosswork sandbox, I am unable to access Crosswork per these instructions within the lab:CrossworkAddress: https://10.10.20.42:30603/Username: adminPassword: Adm!n123!10.10.20.42 pings successfully, but I am unable to access the Cr...
Hello,I am working with NETCONF/RESTCONF and MDT (TIG Stack) on the IOS XE on Cat8kv reservable sandbox. I have not been able to figure out how to stream interface state via on-change. For reference, I am using the basic ietf-interfaces.yang model....
I am unable to log into the XR or Nexus nodes on the IOS XE on Catalyst on Latest Code reservable sandbox. The sidebar lists the creds as developer/C1sco12345. This does not work for either. I can get on the XE node though. Am I supposed to be ab...
I forgot to mention that I have tried multiple Crosswork sandbox environments to no avail. There seems to be an issue with Crosswork specifically, as NSO is accessible.
I was under this impression too, but what has me skeptical is that not a single "on-change is valid" is not set to [null]. Perhaps this is a limitation on the sandbox environment. Thank you for your help.
Below is a snippet of the router's reply after GETing Cisco-IOS-XE-mdt-capabilities-oper:mdt-capabilities-oper-data { "index": 16, "sub-caps": { "on-change-is-valid": [null], "on-change-supported": "mdt-cap-notif-config mdt-cap-notif-state" ...
Thank you for your help bigevilbeard,I will be GETing the the MDT capabilities model from the router to see what models support on-change.You are correct in assuming I am using the devnet sandbox environment. More specifically, I have been using the...
