Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Issue on Cisco Device Manager:Community column list is showing blank but able to see the Role column.Able to see the Community name from CLI.Able to add/Delete Community from CLI.If I try Add/Delete Community from GUI, getting the error "permission d...
Issue:Community column list is showing blank but able to see the Role column.Able to see the Community name from CLI.Able to add/Delete Community from CLI.If I try Add/Delete Community from GUI, getting the error "permission denied or feature disable...
Hi All,while upgrading the firmware on MDS9509 to 3.2, one of the blade (DS-X9016) failed to update the firmware. No error was reported.Later after looking at the logs, I found the reason was it is a Gen1 blade.Can I upgrade the fimware on a single b...
Hi All,Is there any Weekly/Monthly New Product Launch (NPI) sessions or tech-talk from Cisco to discuss about any known current issues/Best Practices ..?Regards,KK
Hi All,I had problem in saving the zoning on my MDS9124, but when I rebooted the switch, I see the following in y console. tried couple of reboots. No go. Any suggestion would be greatly appreciated.++++++++++++++++>> MDS-Bootloader-01.00.15 (Jul 16 ...
check for Advanced Zoning concept in any Cisco administrator guide. it will teach you about zoning merging.If you understand the basics of zone merging, that will answer all your queries..
Hi...pWWN and nWWN can be same if it is a single port HBA.But in case of Dual port HBA, you will see difference. But its only the last octat would change..If you are getting difference in the first octat, then make sure there is no virtualization app...
