Hi Deepak, Could you verify the config using the link below  and let me know if it works: https://supportforums.cisco.com/document/102461/how-access-cisco-asa-using-asdm Thanks, Ankita ... View more

Hi Peter, You might want to check the below article regarding the overruns: https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/115985-asa-overrun-product-tech-note-00.html Rate and mark correct if it helps. Thanks, Ankita ... View more

Hi, It is https://panacea.threatgrid.com Rate if it helps. Thanks, Ankita ... View more

Hi, No, the warning doesn't affect the traffic at all so you can go ahead and configure the same Nat and test the traffic. Thanks, Ankita ... View more

Hi, In this case, you will have to create two policies as your default policy is deny all. Create first policy: Policy1 - Inside to Outside, GroupA to any, 2-URL-Categories, BLOCK Policy 2 : group A any any allow Please mark and rate helpful posts. Thanks, Ankita ... View more

Hi, Are you facing an issue with polling when secondary interface becomes the active member ? Poll response will only be done by the interface which is on the active box. Thanks, Ankita ... View more

Hi, Thanks for the update. If you are on 9.6 and still observing this issue, I would recommend you to open TAC case so that we can assist you better. Thanks, Ankita ... View more

Hi, Could you share the ASA version you are running ? If you are running 9.3 and below then you need to upgrade to 9.3.2 for the fix. "Use other syslogs such as 302013 or 302015 to track connection builds." suggests that you can use the above two syslog id's to track same information for which the error is generated 106100 etc. Rate if it helps. Thanks, Ankita Thanks, Ankita ... View more

Hi, It might be the case if connections are not cleared when idle, check if the idle time out is too much for connection and try to reduce it and check if this error goes off. Rate if it helps. Thanks, Ankita ... View more

Hi, You might want to check this bug  CSCtt88306 which explains the same issue due to hash calculation issue. Rate if it helps. Thanks, Ankita ... View more