@Marco Antonio Canales Naveda
Yes, I have done it without using the auth URL. Usually this is when you want to add another site there is a centralized CUCM with InformaCast installed currently and SIP integration is not a valid solution.
This is when you have to do a CTI integration. If you have any questions let me know.
... View more
Since it's directly connected wouldn't that cover the return traffic? This is from the 2851 router. The IP of the Comcast gateway is 10.25.12.1 /24. The interface connecting to the gateway is 10.25.12.2 /24. Here's what I have: S* 0.0.0.0/0 [1/0] via 10.25.12.1 10.0.0.0/8 is variably subnetted, 7 subnets, 2 masks C 10.25.1.2/32 is directly connected, Loopback0 C 10.25.11.0/24 is directly connected, GigabitEthernet0/1.11 L 10.25.11.2/32 is directly connected, GigabitEthernet0/1.11 C 10.25.12.0/24 is directly connected, GigabitEthernet0/0 L 10.25.12.2/32 is directly connected, GigabitEthernet0/0 C 10.25.110.0/24 is directly connected, GigabitEthernet0/1.110 L 10.25.110.2/32 is directly connected, GigabitEthernet0/1.110
... View more
Hi everyone, I have a Comcast wireless gateway, a Cisco 2851 router, HP DL380 (used for VMware and UC applications), and a 3750 switch. I want to be able to run Call Manager and other voice applications, but I think my Comcast wireless gateway is limiting me from doing so, there is no way (that I know of) to access the routing table on the Comcast wireless gateway. This is preventing the traffic from my lab from getting to the internet (I believe). I need to access the internet because Call Manager and other UC applications have to access it for an NTP reference. My setup is as follows: HP DL 380 ----> 3750 switch ----> 2851 router ----> Comcast wireless gateway ----> Internet Here are the details of each: [ESXi] IP = 10.25.110.16 (connects to switch and is in both voice and data vlan) [3750 Switch] Data vlan = 110 Voice Vlan = 11 fa2/0/48 connection to 2851. Trunk capable of carrying all vlan data with 110 being the native vlan. [2851 Router] Gi0/0 = 10.25.12.2 /24 Gi0/1 = no ip Gi0/1.11 = 10.25.11.2 /24 Gi0/1.110 = 10.25.110.2 /24 Lo0 = 10.25.11.254 /32 [Comcast Gateway] IP = 10.25.12.1 /24 I have tried creating a default route on the 2851 router to the comcast gateway 0.0.0.0 0.0.0.0 10.25.12.1. I have tried pretty much everything that I know. Please let me know if you need more details or have any recommendations. P.S. If you have encountered this and think it would be easier for me to just get a cable modem and hook the 2851 router directly into that I would be willing to do that if this setup isn't possible. My question then is will the 2851 put out 110mbps? Because that is the speed I pay for now.
... View more