I am trying to built an EVPN VPWS service with port-active load-balancing. One end of the VPWS is with two PE's (NCS55A2, PE-1 and PE-2) connected to a customer LAN the other end is a single PE (ASR9K - PE-3) connected to another customer LAN. in bet...
Hey you all I have a very strange problem regarding IS-IS routing process on an ASR903 router, that I hope someone can help me with. I am trying to get IS-IS up and running between an ASR903 router and a ME3600X switch. Between the two boxes is a ser...
Hi @xthuijs So just to be sure, you mean just to create a "flat" single level policy and place that on the main interface? Like this: class-map match-any WHOLESALE-EF
match cos 5
match dscp ef
end-class-map
!
class-map match-any WHOLESALE-AF
m...
Hi @xthuijs I am trying to built a QoS policy that should work across a large number of sub-interfaces on the same main (bundle) interface. On each sub-interface a large number of different customers with different services are running. What I need ...
IT look like that even though that port-active mode is configurable in 6.6.3, it is not supported before 7.1.2. I upgraded the routers to 7.2.2 and then the EVPN come up.
Hi I have been following that tutorial without luck. It is also for a E-LAN and not E-LINE however it should work. Debug did not show much but here are what I see when debugging: debug l2vpn errors
RP/0/RSP1/CPU0:bord02.arc01#RP/0/RSP1/CPU0:Jan 20 ...
Hi @Bruno De Oliveira Novais Thank you very much for the fast answer!Do you know if there are a planned release where MDT data will be supported?Also then if I understand it correct without the MDT data will that not mean that all PE's in the networ...
