Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Recently I tried to setup the DDNS with ovh.com using the HTTPS method. During the process i get the current error:
*Mar 17 10:57:18.570: HTTPDNSUPD: Call returned Request Aborted, update of sun.homenetwork <=> 79.42.60.68 failed
*Mar 17 10:5...
Hello, I just configured DNS server on my cisco 1941. From the router, i can translate google.com and ping the world. As a switch I have the EHWIC-D-8ESG-P and the EHWIC-VA-DSL-A as modem. The machines can comunicate from each other:sun (the default ...
Hello guys, this is my first post on the forum and i'm new in the cisco world. I recently bought my first router, a Cisco 1941, to which I added the module EHWIC-D-8ESG-P. I want to connect the WAP371 on it. Upon connection, I realized that the AP wa...
Hi Alex, this morning i solved the problem. Was caused by a wrong config of dhcpd.conf, dns, static routing on the end terminals. The router was configured properly.Thanks for the support.Mauro
Hi Alex, I have attached my last config, and some test as you can see belove. I'm still not able to reach the WAN from the LAN.
The routing table from mars.homenetwork
realnot@mars ~ $ route
Kernel IP routing table
Destination Gateway G...
Hi Alex,
Firts of all, thanks for the reply. While you answered i was writing
I tried your suggestions and I edited my config, but I'm still not able to go on the WAN. The first problem is to ping the router 192.168.1.1. How can I assign an IP ...
Partially solved... the Cisco EtherSwitch EHWICs support the layer 3 features as NAT, QoS and other services with VSI and not directly. Here fe features list. In other word to use nating on modules you have to create a vlan interface and assign the i...
The problem seems solved, I was able to set up the interfaces gigabit ethernet 0/1/0 0/1/1 and 0/1/7 with no shutdown, switchport mode access and switchport access vlan 1. The switch seems to work as a normal switch layer 2, without the PoE functiona...
