I have a cisco 2900 series building a site-2-site vpn tunnel to an ASA 5510. The tunnel establishes just fine but I am unable to get traffic to flow through the tunnel. I have read several other posts and tried many of the suggestion (probably ...
Genious! Thank you so much! That did the trick, I knew it was something small like that but a fresh set of eyes was just what I needed! now I just have to figure out why my vpn traffic isn't being exempt from the firewall rules.
Ok, I removed the "ip nat" statements from the interfaces and here is the output you requested: ASA:IKEv1 SAs: Active SA: 1 Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 11 IKE Peer: *.*.*.* Type : ...
Poor choice of words on my behalf, I understand I can use a dynamic crypto map but we choose not to for security purposes and this is just in testing stages so ideally we will have a static address to use eventually. I don't have any problem bringin...
The router's default gateway is a 3G CradelPoint router assigned 192.168.100.1 and acts as the internet gateway which recieves a dynamic public address (yes I know I have to change the peer and crypto map IP on the ASA every time this changes). The ...
Thank you so much for your response. I changed the nat rule on the ASA as advised along with executing the clear xlate command, however, I'm not sure if it is a typo but you have "any"after the first network object in the nat rule and it does not fi...
