Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good afternoon everyone,I'am a newbie at configuring cisco routers, I had made a few month ago a VPN tunnel between 2 sites. Site A had the VPN server on a cisco SR520-ADSL-K9 network is 192.168.1.0 (public IP is 80.11.82.100 (not real). Site B is th...
Good afternoon everyone,I'am a bit newbie at using Cisco products and here is my problem : I have set up a VPN tunnel between 2 Sites (A and B) a few month ago using 2 cisco SR520-ADSL-K9. All was working fine until power failures occured on the site...
You will find below the configuration of the Server if it can helps in diagnostic.Best regardsCurrent configuration : 9081 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service passwor...
I just did the following command : copy startup-config running-configDoing this made the router beeing accessible via network and CCA. But once I reboot the router, I lost this connection and configuration.Any way to make the router keep the new runn...
I think it would be helpful to add the result of the "show configuration" command :Router#show configurationUsing 4812 out of 131072 bytes!version 12.4no service padservice timestamps debug datetime msecservice timestamps log datetime msecno service ...
