Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I’m looking for some specific parameters of Cisco 1941 and not able to find them and just wander if somebody can help me.1. Maximum number of DHCP clients2. Maximum number of DHCP pools3. Maximum number of VLANs on trunck portBest Regards
Hi,I have some problems with Cisco VPN PPTP server on mine router and just wander if somebody can help me.Basically after configuration was set, I’m able to connect to the device using Microsoft VPN client, also getting IP address from PPTP-pool (10....
Hi,I have problem with VPN point to point on my Cisco 877 router and just wander if somebody could help me. I tried to set it using CCP wizard as well as console but without any success. Basically when I test tunnel I’m getting errors: “The peer must...
Hi Raul,In my case problem was in CCP 2.6 (Cisco makes so good systems but their graphics tool is full of bugs). Basically first of all I used wrong per external – just mistake in numbers but test shows the error which makes my troubleshooting more d...
Jouni,Thank you for your reply.Answering for your questions: “The error messages just seem to point to that you are lacking routes? Yet you have a default route configured.”But what kind of routing? I set many VPNS and never had to configure routing ...
