About MaxStLedger

MaxStLedger · 12-11-2023

Switch Configuration Switch 1 - Port 1/0/7 to CPE Port 1/0/8 to Switch 2 Port 1/0/5 Switch 2 - Port 1/0/8 to Swith 3 Port 1/0/5 Switch 3 - Port 1/0/6 to untagged device on VLAN 1130 Port 1/0/5 & 1/0/8 - Trunk - Tagged 2500 Port 1/0/7 - Customer Mod...

MaxStLedger · 01-02-2024

Hi, Did you have any ideas as to what could be causing the insufficient resource allocation error message? Thanks

MaxStLedger · 12-13-2023

I am now working on just the one switch, I have attached an updated topology. There are two VLANS on SW1 - 2500 and 1130 I am following the steps on the Cisco website - Here and when I reach step 9 I am given 'Cannot create new VLAN mapping due to ...

MaxStLedger · 12-13-2023

I am trying to follow the configure VLAn mapping guide on cisco and it is giving the following message: 'Cannot create new VLAN mapping due to insufficient resource allocation' Do you have any idea why this is happening, I think this could be the way...

MaxStLedger · 12-12-2023

It needs to come out the other end tagged or untagged as 1130 and not a customer port, do you know how this can be achieved? Thanks

MaxStLedger · 12-12-2023

Hi M02@rt37, Thanks for the reply I am using CBS350 switches and these do not have the command: SW1(config-if)#switchport mode dot1q-tunnel I have the following options in switchport mode: generalaccesstrunkcustomervlan-mapping private-vlan I am als...

Member Since	‎12-11-2023 06:30 AM
Date Last Visited	‎05-30-2024 01:01 AM
Posts	8
Total Helpful Votes Received	2

User Statistics

User Activity

QinQ Question

Re: QinQ Question

Re: QinQ Question

Re: QinQ Question

Re: QinQ Question

Re: QinQ Question