Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:I have a Cisco 5613 with module WS-6748-GE-TX, one of the interfaces is connected to a Sun E2900 server with Gig ports. What is the proper setting for this to run at Gig/full? What about the Sun settings?We tried letting it auto negotiate from...
Having some issues with connecting a Extreme Black Diamond, with Cisco 6506. Bundling 4 802.1q Gigabit trunks into a Channel-group(Port-channel). We cannot use PAgP(Cisco proprietary ). So, we tried LACP, which is IEEE 802.ad(?) almost connects, b...
I am running OS 6.4(3) on a PIX 515e, with 64MB RAM. Windows XP Workstations behind the firewall, Oracle Server in front. Browser on workstation using port TCP: 8006 cannot hit server. Does the PIX have any issues with this port? I know very litt...
Had Aironet 4800 PCMCIA card running fine under WIN98SE. Upgraded system to WIN2000-PRO, loaded new drivers, firmware for 4800. Associates and then drops conn. due to "Radio on 4800 is turned off". I turn it back on and in less than 1 minute same ...
Is it true that you have to turn on the LACP channel protocol on each interface participating in the channel-group ? like thisinterface>channel-protocol lacp
Another colleuge suggested putting an ACL for that specific port, and server address. I am kind of skeptical because it is wide open right now. What do you think?
Well, I tried with the latest firmware, drivers, ACU. Not working. The radio goes off at will. Now I have it working with ACU 5.01.0001, and its appropriate firmware, drivers(legacy). Thanks for your suggestions, but I am happy with this version.
