my NM-16A in cisco3661 can not answer call,but U.S.robotics modem can .when I use reverse telnet to the modem, it shows no dial tone, i also use x3 to ignore the dial tone, it shows no carrier. Are some ways to solve this?
The 8A/S card for 2600/3600 support max speed 128Kbps at sync. according to cisco documents, but when I use NetIQ's QCheck to test the network throughput on a point-to point connection between two 8A/S card, it shows a throughput of 240Kbps~245kbps w...
Thanks, Mak.1.When using reverse telnet to modem, I can't dial out, it indicates NO DIALTONE.2.I have issued AT&FS0=1,no success.3.I have issued ATS6=5 to wait for dialtone,no success.4.I have issued ATX3 to ignore the dialtone, it indicate NO CARRIE...
