Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
You do not need to change the APIC connectivity preference.
Without reviewing your configuration, I'll share a common mistake when configuring InBand MGMT and the APIC is not working. Ensure that your Inband BD VLAN is configured in the VLAN pool f...
My apologies, I read your question on my phone and did not read it thoroughly before responding.
You can run with 1 Spine and simply add the other Spine later. You just connect them up and it will appear in the APIC GUI for fabric registration just...
You are going down the correct path since your K8 nodes are VMs then Floating L3 out is the correct configuration. This is done so that if your K8 nodes move between vPC pairs then your L3 connectivity will still remain.
Do I need to add node info...
Hello Kumar,
You need to add status="deleted"
See an example below.
<fvTenant descr="" dn="uni/tn-PVGAS" name="PVGAS" ownerKey="" ownerTag="">
<fvAp descr="" name="PVGAS" ownerKey="" ownerTag="" prio="unspecified">
<fvAEPg descr="" matchT="Atle...
