Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My question:Is there a way to force a bridge domain to use a specific L3out when multiple l3outs with default routes exist?My situation:I currently have a firewall acting as the default gateway for several networks/VLANs. The firewall has a unique "I...
Good day,I have an existing production fabric and I'm spinning up a Greenfield DR fabric. I am worried about potential service impact(s) to my production fabric when adding it to multi-site. The "tl;dr" of my post is: Is there a service impact when...
Hello all,I have a typical network-centric fabric design. I have a need to create several L3Outs between ACI and a pair of ASAs (multiple contexts). Even though we will only be doing static routing across these L3Outs, it appears I am still require...
Greetings all,I have a prod ACI fabric running 4.2(7s) in network-centric. Connected to this fabric is a VMware cluster consisting of around a dozen physical ESXi hosts. We're doing VMM integration, so there aren't any static path bindings for these ...
I need to upgrade our production fabric from 4.2(3l) to 4.2(7s). As part of the upgrade, it appears that my APICs require an CIMC/HUU update. I have the following questions:Are there any major issues with upgrading the APIC cluster on one day and ...
I don't have a suggestion, but I've noticed the same thing and I'm running6.0(9d). I suspect it's a bug since I'm able to successfully clone similarobjects in my lab fabric running 5.2 in the same web browser.
I'll go ahead and answer my own question to close the loop.The abstraction of the ACI GUI makes it look like this should work, however, the answer became apparent after checking the VRF routing table via the CLI. Regardless of the L3Out, adding a se...
It's not intuitive, but click on the icon for the upgrade group under the"Status" column (i.e. "Completed", "Ready to Install", etc), and it shouldlaunch a new status window. From there, click the pencil icon at thetop-right and you should be able to...
I've moved a single APIC to a new leaf switch pair in the past. I had to power the APIC down to relocate it, connected it to the new switches and powered it back up. Everything worked fine.I will say that I was left with a cosmetic issue when viewi...
