Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi What should the Consumer Connector BD be set to for L3Out EPG when applying a Service Graph Template? I will explain with an illustration... This is for a unmanaged Service Graph Template for a vADC. Policy is to insert a vADC for Client traffic c...
Hi Multi- Pod deployment, with 2 Data Centers, DC1 and DC2. Configured OSPF L3Out/area 0 at each Data Center over SVI: DC1 SVI subnet 10.13.254.0/29DC2 SVI subnet 10.13.254.8/29 I have applied Tenant common default contract which I understand is the ...
Hi
I will be installing FirePOWER (SFR) Services on ASA 5585-X SSP-10 module
I have ssh session to ASA but I am unable to get a response from the SSP-10.
From the details below please can somebody tell me why I am having this issue and how it can be...
Hi
Customer purchased two Cisco ASA 5585-X with the default licenses:
ASA5500-ENCR-K9 ASA 5500 Strong Encryption Lic
ASA5585-SEC-PL ASA 5585-X Security Plus Licen
Please could someone provide me with the answers to the following questions:
E...
Hi
Using ACLs to classify traffic. This includes FTP traffic. However Catalyst 3750 switch is not marking the traffic.
I have attached snippets from the configuration and details when testing FTP traffic. According to the configuration this traffi...
Supported since April 2019 in Cisco IOS XE Gibraltar 16.11.1 https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9400/software/release/16-11/release_notes/ol-16-11-9400.html
Hi there
I am getting the same '....interface Configured as L2' error message for an access port which I have configured as a L3 Out OSPF point to point connection.
Outputs below:
FMC-Apic-1# show running-config leaf 132 interface eth 1/46# C...
