Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I've read the MX_warm_spare_-_high_avialability_pair documentI understand to configure my static ip on my wan via the local status page. In all the examples it just shows the VIP address, where do I configure the distinct uplink IP and choose...
Hi all, I have my opinion, but looking for any more reasons to add to my choice of which option to use when building my MX HA Devices. What is the most common choice? MX Uplink IPs or Virtual Uplink IPs?I think you get more redundancy of VRRP heartbe...
Hi all, I have a port that reports its 'no connected clinets on this port for selected time range'. I know the reason why.When I do a packet capture i only see broadcast/mcast traffic. The stats for packets is zero for received and populated for sent...
On my Meraki do I simply configure my desired two uplink ports with native vlan and allowed vlans. Then select them both and choose Aggregation. Then control the negotiation etc from my upstream Cisco Catalyst with matching configuration?Lastly, how ...
Hi, I'm planning to retain a Catayst Core running rpvst and keeping it as root. As long as I allow vlan 1 over the trunks to the MS switches will I have compatibility whilst retaining my current Catayst rpvst config?I got this from Meraki support:"If...
Thanks, I have tried that. My only option that is not greyed out once I tick a port, is édit', and this gives me the window to only change the description.Its a MS225-48LP switch.
