Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello! I have a 3504 controller connected to an AIR-AP1832I-R-K9 AP running iOS 8.5.140.0. I'm currently desperate for faster Wi-Fi. My laptop shows a great signal, but the actual speeds aren't even close. The AP itself isn't overloaded with clients....
Hello!I want to set up a WebGUI for my colleagues on a Cisco 9300, running iOS 17.12.4. While I know how to set specific privileges for a specific level using the CLI, I don't understand how to do this using the WebGUI. I need to grant access to Trou...
Hello!There is such a problem in the network. There is a C9500-40X core, it is responsible only for the user segment of the LAN (desktop PC, IP phones, printers, air conditioners, UPS, video cameras, etc.). Eleven floors are connected to it via MM fi...
Hello.After a small power failure, one of the Nexus 9k, after loading, began to reboot after 5 seconds and so on in a circle. I decided to reset the configuration via boot loader, as a result, now the system does not load, I did this at the start of ...
Hello!According to the diagram, the organization receives the Internet from the provider via Vlan 1200, which wraps two address pools (let's assume those in the diagram). The provider's equipment is connected to the C9300-24UX-A, then the Trunk goes ...
Thanks! I changed some settings from the link. My phone connected to 5G, and the speed was fine; it was even better on another phone. I also tested it on a newer laptop, and it also showed good speed. Apparently, my test laptop is a bit old.
Yes, you are right, the function is enabled. I looked yesterday, it was disabled everywhere. Today I tried to raise PO, but nothing happened. In the end, I disabled PO on the floor and on the core again. About a minute later the entire network went d...
