About Audrius Jonavicius

Audrius Jonavicius · 12-29-2011

Hi,I am planning to create High Availability for LAN to WAN connectivity.But I want to know your opinion about the best way how to do this. I googled for a solution/best way how to do this, but I didn't found in my opinion right answer.The situation:...

Audrius Jonavicius · 04-16-2021

Hi, I think that now it is possible. Take a look here https://community.cisco.com/t5/networking-blogs/xfsu-on-catalyst-9300-the-always-on-access-network/ba-p/4273159 Regards,Audrius

Audrius Jonavicius · 08-15-2012

To be honest from your post I don't understand location of the switch. I assume that your network is designed as follows and 2950 is yours:ISP->Router->2950Switch1. If you can access internet from the PC, so you know the subnet, where your network re...

Audrius Jonavicius · 08-13-2012

Hi,try to set "ip tcp adjust-mss 1360" on router interface looking to the LAN side.This need to be done on both sides.Regards,Audrius

Audrius Jonavicius · 04-10-2012

I would recommend to read this guide http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoSPref.html

Audrius Jonavicius · 04-10-2012

Hi,I would recommend to look at Nessus or NeXpose Vulnerability assesment/managment tools.Regards,Audrius

Member Since	‎12-01-2011 11:12 PM
Date Last Visited	‎05-09-2023 02:44 AM
Posts	15
Total Helpful Votes Received	10

User Statistics

User Activity

Best practice for High availability design, HSRP

Re: C9300 Stack OS Upgrade non-downtime

Re: How can I determine the IP address of my Cisco 2950 switch?

Packets: icmp unreachable need to frag (mtu 1416)

Catalyst QOS guru needed

Vulnerability assesment Tool