Hello Everyone, I am trying to understand the difference between User and Machine Authentication. The real question is what gets sent when I use machine Auth? Is it the hosts Mac address, or host name when I first plug in to a 802.1x enabled port...
From the capture, it seems that the 10.10.10.3 HP host is sending resets. This could be a application layer problem with the IME, or something on that PC is causing the connection to reset. If this is a clean HP host, then it has to be the IME softwa...
Can you try to do a packet capture on the ASA, and IPS when trying to access both from the troubled areas of the nextwork? I am thinking this might be a networking problems so where, if not, it might be something to do with the IPS module.Thanks,Rafa...
This sounds like a IP issue some where on the ASA, or IPS module. Did you run a capture on the ASA, and the IPS module to see if the respones are arriveing? On the issue, you can use the "capture interface " on the ASA, and the "packet display expr...
To my knowlege, this is not really supported. I am sure with some tickering, you might get it to work, but i doubt it. The only options supported are listed on this link: http://www.cisco.com/en/US/docs/security/ips/7.0/configuration/guide/cli/cli_sy...