Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm considering getting WLSE. I have 100 AP's in 33 buildings on a small campus, so a big part of the job is entering floorplans and AP locations. Does WLSE properly handle relations between devices on different buildings and floors? If so how doe...
Each of my 80 Aironet 350 AP's (all with 12.02T1 firmware) drops all its clients about one to ten times a day with this log message for each client:Disassociating [al]00022d1b5416, reason "Sender is Leaving (has left) BSS"Within a few seconds that's ...
Thanks for your reply.The data sheet says WLSE 2.5 can manage up to 2500 AP's, but my concern is whether it correctly maps coverage areas in three dimensions (between floors) and considers AP's in nearby buildings. I don't see anything in the data s...
We have all 350's. We seem to have solved this problem by downgrading to 11.23T and/or disabling VLAN support in 12.02T. Here's what we've done:1) Downgraded five AP's (of 150) to 11.23T. None of the five have had dropouts in many days, though t...
Thanks very much to Cal and Paul for their suggestions.I've reset all my 80 AP's to "no action" on loss of Ethernet, but I still get the "leaving BSS" connectivity dropouts that temporarily disconnect all clients on the AP and that terminate AIM, put...
Another consequence would be that the polarization of the transmitted signals would be horizontal instead of vertical. If the other end of the link is still vertical, then you loose signal strength. Since most antennas are set up for vertical polar...
I have this problem, too, and I've just entered some details as a reply to the originall poster of this thread. Let me reply to your questions as they relate to my case:In my case, there is no amplifier on any of our AP's.In my case most (at least) ...
